Rep 8.7 Holder Linear Motor Replacement M15 - GBC eWire Service Manual

Installation Procedure
1. Install the new Sensor by tightening the M3 Screw. Use tab for
alignment.
2. Connect the Sensor Cable.
3. Close the Lid
4. Connect the Power Cable
5. Turn power ON to the eWire.
GBC eWire

REP 8.7 Holder Linear Motor Replacement M15

PARTS LIST ON PL 5.21
Use this procedure to remove and install the Holder Linear Motor, M15
Removal Procedure
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.5 Back Cover Replacement
4. Loosen the Set screw securing the Drive Pulley to the Motor shaft.
5. Disconnect the Motor Cable from the Stepper Driver Board.
01/26/2018
4-149
WARNING
to remove the Back Cover.
Repairs/Adjustments