Rap 4.4 J323- S23 Knife Home Timeout; Rap 4.5 J324- S24 Pushover Home Timeout - GBC eWire Service Manual

RAP 4.4 J323- S23 KNIFE HOME TIMEOUT
S23 Knife home time out is the maximum time to wait for the Knife to
reach home.
1. Do GP 6.4 to check S23 Knife Home sensor.
This clears the fault
Yes- Return to normal operation
No- Go to Step 2
2. Do GP 6.5 to check M11 Knife Motor
This clears the fault
Yes- Return to normal operation
No- Go to step 3
3. Do GP 6.3.7 FIRMWARE UPGRADE Procedure to Re-flash the
firmware for eWire.
This clears the fault
Yes- Return to normal operation;
No- Go to Step 4
4. Replace the Knife module (REP 3.15)
This clears the fault
Yes- Return to normal operation
No- Go to Step 5
5. Do REP 11.3 "B" Main Control Board Replacement.
This clears the fault
Yes- Return to normal operation;
No- Escalate to second level
GBC eWire
RAP 4.5 J324- S24 PUSHOVER HOME TIMEOUT
S24 Pushover home time out is the maximum time to wait for the Element
transfer pushover assembly to reach home.
1. Do GP 6.4 to check S24 Pushover Home sensor.
This clears the fault
Yes- Return to normal operation
No- Go to Step 2
2. Do GP 6.5 to check M12 Element Pushover Motor
This clears the fault
Yes- Return to normal operation
No- Go to step 3
3. Inspect Pushover cams for signs of wear (PL 5.13)
Pushover cam shows sign of wear
Yes- Replace Element Pushover cams (REPs 3.16.5 and 3.16.6)
No- Go to Step 4
4. Inspect Element Pushover springs, ensure they are installed properly
(PL 5.13)
Element Pushover springs shows sign of wear
Yes- Replace Element pushover springs (REP 3.15.12)
No- Go to Step 5
5. Inspect the Element Pushover for obstructions. Remove any debris or
parts that may have fallen into the cavity.
Element Pushover is free of obstructions
Yes- Go to Step 6
No- Clear the area and re-test
6. Do GP 6.3.7 FIRMWARE UPGRADE Procedure to Re-flash the
firmware for eWire.
This clears the fault
Yes- Return to normal operation; No- Go to Step 6
01-26-2018
2-32
RAPS