Rep 8.15 Linear Spring Plate Assembly - GBC eWire Service Manual

Installation Procedure
1. Thread the M3 Screw and Nut through the end of the extension
spring and attach the Screw to the Holder. Secure using the M3
Nut.
2. Repeat the Procedure to secure the opposite end of the spring.
3. If necessary, repeat the procedure for the Holder Gates Upper
Spring on the opposite side of the Holder.
4. Connect the Power Cord
5. Turn power ON to eWire.
Repairs/Adjustments

REP 8.15 Linear Spring Plate Assembly

PARTS LIST ON PL 5.21
Use this procedure to remove and install the Linear Spring Plate
Assembly
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Lid and Lower Bypass.
4. Open the Book Tray Door and locate the Linear Spring Plate
Assembly on the bottom side of the Holder.
5. Remove the M4 Screws (2) and remove the Linear Spring Plate
6. If necessary, repeat this procedure for the second Linear Spring Plate
Assembly.
01/26/2018
4-158
GBC eWire