GBC eWire Service Manual page 316

Repairs/Adjustments
Top surface of tool should
line up with this point
Adjustment Procedure
1) Do GP 6.1.3 to enter the Service Menu. Select Element at Stack
Position, which can be incremented from -50 to +50. Increasing this
value will raise the element tips and decreasing it will lower the
element tips.
2) Raise or lower the Element at Stack value by 5.
3) Insert a cheater into the Lid Interlock
4) When motion stops remove the element from the holder
5) Repeat the Inspection Procedure
6) When the Element wire tip position is correct, return to the procedure
that directed you here. NOTE: THIS PROCEDURE ONLY EFFECTS
THE ELEMENT SIZE CURRENTLY LOADED AND MAY HAVE TO
BE REPEATED FOR OTHER SIZES.
01/26/2018
4-200
GBC eWire