Rep 3.13 Element Engagement Guide Replacement - GBC eWire Service Manual

Installation Procedure
1. Slide the new Element Sprocket Nose Assembly onto the housing
and align it to the Element Feeder frame.
2. Secure the new Element Sprocket Nose Assembly to the frame using
the M4 Screws (3).
3. Tighten the Set Screw to secure the Sprocket Feeder Shaft to the
Stepper Motor.
4. Install the plastic Knob onto the Sprocket Feeder Shaft and secure it
using the Set Screw.
5. Connect the Power Cord.
6. Power ON the eWire.
Repairs/Adjustments

REP 3.13 Element Engagement Guide Replacement

PARTS LIST ON PL 5.9
Use this procedure to remove and install the Element Engagement Guide
Assembly.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Front Door and Slide the Element Feeder out.
4. Remove the M4 Screws (4) securing the Element Engagement Guide
to the Element Feeder.
5. Slide the Element Engagement Guide towards the back of the
machine to remove it. Take care not to damage the Feeder Belt teeth.
The middle plate on the Element Engagement Guide runs in the
center gap of the Belt Teeth.
01/26/2018
4-70
GBC eWire