GBC eWire Service Manual page 377

Locate Sensor S20:
•
Slide the Element Feeder Drawer all the way out of the
machine.
•
Remove the Element Spool
•
Manually actuate the sensor slack mechanism to block or
unblock the sensor. If there is dust or debris located at the
bottom of the Element Feeder, vacuum the area around the
slack sensor.
•
If actuating the Slack Sensor mechanism is inconclusive,
follow REP 3.1 to remove the Slack Sensor mechanism and
gain direct access to the Sensor.
S20 is located at the bottom of the Element Feeder Assembly. It can
be blocked or unblocked by pressing manually on the Slack
Detect mechanism.
General Procedures and Information
Locate Sensor S21:
•
Slide the Element Feeder Drawer all the way out of the eWire.
WARNING
Moving Parts, keep hands clear of all moving parts when
the Interlock Cheater is inserted. Keep fingers away from
the Knife Mechanism when power is on. See Section 0,
page vii for other languages.
•
To check S21, slide a piece of paper above the knife blade
until it contacts the back frame of the Element Feeder.
S23 is located on the Knife Module
01/26/2018
6-26
GBC eWire