GBC eWire Service Manual page 197

12. Remove the M4 Screws (2) supporting the upper portion of the
Element Transfer Module.
13. Remove the Element Feeder Belt Cover by removing the M4 Screws
(2).
GBC eWire
14. Remove the M4 Screws supporting the front of the Element Transfer
Module.
15. Remove the Element Transfer Module by lifting it straight up out of
the Element Feeder.
Installation Procedure
16. Carefully slide the Element Transfer Module into position on the
Element Feeder. Secure the Element Transfer Module using M4
Screws (4).
17. Replace the Element Feeder Belt Cover.
18. Replace the Element Feeder Back Cover by Securing the M4 Screws
(8). The bottom screws can be used as a support to help position the
cover.
19. Replace the Element Feeder Upper Cover
20. Connect the Power Cord.
21. Power ON the eWire.
01/26/2018
4-81
Repairs/Adjustments