GBC eWire Service Manual page 249

REP 6.4 Closer Motor Replacement M20
PARTS LIST ON PL 5.19
Use this procedure to remove and install the Closer Motor M20
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 6.1 Closer Module Replacement
4. Disconnect the Motor Cable at the header.
GBC eWire
to remove the Closer.
01/26/2018
5. Disconnect the Motor from the Frame by removing the M5 Screws (4)
6. Slide the Motor out of the Closer.
7. Remove the Gear from the Motor by loosening the set screw and
sliding the Gear off the shaft.
4-133
Repairs/Adjustments