Rep 3.2 Element Detect At Pyramid Sensor Replacement - S22 - GBC eWire Service Manual

Installation Procedure
1. Reverse the steps in the Removal Procedure.
2. Connect the Power Cord.
3. Power ON the eWire.
Repairs/Adjustments
REP 3.2 Element Detect at Pyramid Sensor Replacement – S22
PARTS LIST ON PL 5.7
Use this procedure to remove and install the Element Detect at Pyramid
Sensor. Note: The S22 Sensor consists of two parts – an Emitter and a
Receiver.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Open the Front Door and slide out the Element Feeder drawer.
4. Do GP 6.8 to remove the Supply Spool.
5. Do REP 3.6 Element Feeder Belt Replacement
Element Feed Belt.
6. Remove the Sensor Cover by removing the M4 Screws (2)
01/26/2018
4-50
to remove the
GBC eWire