Rep 3.3 Element Belt Home Sensor Replacement - S25 - GBC eWire Service Manual

Installation Procedure
1. Use caution when handling the new Emitter and Receiver PCBs as
the wires could be damaged if too much force is applied.
2. Using the M2 Screws, mount the new Emitter PCB to the Mounting
Plate.
3. Using the M2 Screws, mount the new Receiver PCB to the Feed
Track Assembly.
4. Reverse the steps in the Removal Procedure to reinstall the rest of
the Element Feeder components.
5. Connect the Power Cord.
6. Power ON the eWire.
Repairs/Adjustments
REP 3.3 Element Belt Home Sensor Replacement – S25
PARTS LIST ON PL 5.7
Use this procedure to remove and install the Element Belt Home Sensor.
Note: the S25 Sensor consists of two parts – an Emitter and a Receiver.
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
Removal Procedure
1. Do Step 1 through Step 8 of
Sensor Replacement.
2. Locate the Belt Detect Sensor Bracket on the bottom side of the
Element Feed Track Assembly. Note: it is not recommended to
remove the Sensor Bracket, in order to maintain the same location for
the new Sensors.
3. Remove the M2 Screws (2) to remove the Emitter PCB.
01/26/2018
4-52
REP 3.2, Element Detect at Pyramid
GBC eWire