Adj 1.3 Holder Mating To Element Feeder - GBC eWire Service Manual

ADJ 1.3 Holder Mating To Element Feeder

For proper operation, the element holder module should mate to the
element feeder without any hesitation or mechanical resistance. The two
locating pins on the element holder should smoothly engage the element
feeder.
Adjustment Procedure
1) By hand, move the element holder towards the element feeder and
note the alignment of the two modules.
2) If the element holder locating pins struggle to align with the element
feeder locating holes (See Fig 2), then the position needs to be
corrected.
a) Check the horizontal alignment as shown in Fig 2.A and Fig 2.B.
i) If an adjustment is needed, loosen the screws for the element
feeder stop latch assembly (Fig 2.C) and adjust the position
of the element feeder.
ii) After adjustment, attempt to engage the holder into the
element feeder by hand again while checking the alignment.
Repairs/Adjustments 01/26/2018
4-188
GBC eWire