Rep 8.8 Holder Linear Motor Replacement M21 - GBC eWire Service Manual

6. Remove the M4 Screws (4) to remove the Holder Linear Motor from
the Standoffs.
7. Slide the Motor out of the pulley shaft and remove the motor.
Installation Procedure
1. Reverse the steps in the Removal Procedure.
Repairs/Adjustments

REP 8.8 Holder Linear Motor Replacement M21

PARTS LIST ON PL 5.21
Use this procedure to remove and install the Closer Linear Motor, M21
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.5 Back Cover Replacement
4. Do REP 1.6 Side Cover Replacement
Side Cover.
5. Loosen the Set screw securing the Drive Pulley to the Motor shaft.
6. Disconnect the Sensor Cable from the Closer Home Sensor S46
(refer to REP 8.1 Closer Staged Sensor and Closer Home Sensor
S46 & S49).
7. Disconnect the Motor Cable from the Stepper Driver Board.
01/26/2018
4-150
to remove the Back Cover.
to remove the downstream
GBC eWire