Gp 6.6.4 Check L8 Holder Lock Solenoid - GBC eWire Service Manual

GP 6.6.4 Check L8 Holder Lock Solenoid
To access Solenoid L8:
•
Raise the top cover by releasing the latch
•
There are two L8 solenoids located on the holder module, refer to
PL 5.22
•
Open and close the lid or door to home the Holder Module.
•
Insert a cheater into the interlock switch for the upper bypass
assembly.
Moving Parts, keep hands clear of moving parts when
the Interlock Cheater is inserted. See Section 0, page
vii for other languages.
1. Do 6.2.5 SOLENOIDS Procedure
L8
•
The holder lock mechanism should cycle closed and open
when L8 is activated
•
Note that both the front and back solenoids should cycle
when activated
Holder Lock mechanism cycles forward and back when L8 is
cycled
Yes- Return to the RAP that directed you here
No- Go to Step 2
GBC eWire
WARNING
to activate and deactivate Solenoid
2. Make sure the solenoid wire is connected securely at the header and
at the Main Control Board (PL 5.27). Do REP 1.5 to remove the Rear
Cover to gain access to the connector at the Control Board. Refer to
GP 6.26 for termination locations.
All the connectors are securely connected.
Yes- Go to Step 3
No- Make the connection and resume operation
3. Check that the cable(s) connecting the Solenoid to the Main Control
Board are intact. Refer to the solenoid cables table to identify the
appropriate cable part numbers, refer to
The cables look okay
Yes- Go to Step 4
No- Identify and replace the faulty cable
4. Do GP 6.3.7 FIRMWARE UPGRADE Procedure
firmware for the eWire
This clears the fault
Yes- Return to normal operation
No- Go to Step 5
5. Replace 7717746 Holder Lock Solenoid L8, refer to REP 8.16
This clears the fault
Yes- Return to normal operation
No- Go to Step 6
6. Replace 7716612 Holder Lock Assembly, refer to REP 8.17 Holder
Lock Sub-Assembly Replacement
This clears the fault
Yes- Return to normal operation
No- Go to Step 7
7. Do REP 11.3 Main Control Board B Replacement.
This clears the fault
Yes- Return to normal operation
No- Escalate to second level
01/26/2018
6-55
GP 6.26.
to Re-flash the
General Procedures and Information