Rep 7.5 Tapper Finger Replacement; Rep 7.6 Rear Tapper Assembly Replacement - GBC eWire Service Manual

REP 7.5 Tapper Finger Replacement

PARTS LIST ON PL 5.17
Use this procedure to remove and install the Finger on the Front Tapper
Assembly. Note: The same procedure can be used to replace the Finger
on the Rear Tapper Assembly.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 7.1 Front Tapper Assembly Replacement
Front Tapper Assembly.
4. Remove (2) M3 Screws securing the Finger to the Tapper Arm and
remove the Finger.
Installation Procedure
1. Reverse the steps from the Removal Procedure.
Repairs/Adjustments

REP 7.6 Rear Tapper Assembly Replacement

PARTS LIST ON PL 5.18
Use this procedure to remove and install the Rear Tapper Assembly
Removal Procedure
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Do REP 1.5
4. Disconnect the Tapper Sensor Cable and Tapper Motor Cable from
to remove the
the appropriate headers.
5. Using a long screwdriver, remove the M4 Screws (2) securing the
Rear Tapper to the Frame. Use the access hole in the Frame to
access the screws.
6. Remove the Rear Tapper from the Frame.
01/26/2018
WARNING
Back Cover Replacement
4-142
to Remove the Back Cover.
GBC eWire