Adj 1.7 Interlock Flag Adjustment - GBC eWire Service Manual

ADJ 1.7 Interlock Flag Adjustment

If a CLOSE DOOR, CLOSE TRAY, or CLOSE LID message is shown
even when the door is closed, or the message occurs during operation, it
may be necessary to adjust the Interlock Flag.
Inspection Procedure
1) Check to see if the CLOSE DOOR, CLOSE TRAY, or CLOSE LID
message is shown even when the door is closed. If the message is
shown when the door is closed, or you need to press extra hard on
the door to make the message go away, the interlock flag may need
adjustment.
2) If the CLOSE DOOR, CLOSE TRAY, or CLOSE LID shows up during
operation, or occurs intermittently, the interlock flag may need
adjustment.
3) If scoring is noticed on the interlock switch due to the interlock flag
rubbing on the hub of the interlock, the interlock flag may need to be
adjusted.
4) If the door does not appear to close all the way, but sticks out near
the interlock location, the Interlock Flag may need adjustment.
5) Visually inspect the Interlock Flag position when the door is closed.
The Flag should stop 1-2 mm from bottoming out.
GBC eWire
Adjustment Procedure
1) Open the door and locate the Interlock Flag. This is the metal
component that presses the Interlock switch to keep it closed.
2) Loosen the M3 Screws (2) securing the Interlock Flag Adjust Plate.
3) Shift the Flag Plate forward or back as needed to adjust the resting
position of the Interlock Flag Plate within the Interlock Switch. The
flag should be 1-2 mm short of bottoming out on the Interlock Switch
when in the resting position.
4) Tighten the screws and close the door to confirm the Interlock is
operating as expected.
01/26/2018
4-195
Repairs/Adjustments