Rep 1.9 Lcd Display Replacement - GBC eWire Service Manual

REP 1.9 LCD Display Replacement

PARTS LIST ON PL 5.1
Use this procedure to remove and install the LCD Display.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Switch power OFF to eWire.
2. Disconnect the Power Cord.
3. Raise the Upper Transport Assembly.
4. Remove the LCD back panel by removing the M4 Screws (3).
5. Disconnect the Cables from the LCD Display.
6. Remove the M3 Screws (3) holding the LCD Display to the Top
Cover. Note the location of the black ground strap that is attached to
one of the screws.
7. Remove the LCD Display.
Repairs/Adjustments
Installation Procedure
1. Place the new LCD Display Panel in position.
2. Tighten the Screws (3) holding the LCD Display to the LCD Panel.
Attach the ground strap using one of the 3 screws.
3. Connect the Cables (2) to the LCD Display Panel.
4. Lower the Upper Transport assembly.
5. Connect the Power Cord.
6. Power ON the eWire.
01/26/2018
4-12
GBC eWire