Rep 9.5 Element Feeder Drawer Latch Replacement - GBC eWire Service Manual

4. Locate the female half of the Latch on the bottom of the Frame.
Remove the Latch by removing the M3 Screws (4).
Installation Procedure
1. Install the new Latch to the frame and secure it using the M3 Screws
(4). Install the new Latch to the Book Drawer and secure it using the
M4 Screws (2) and Washers.
2. Adjust the latch position so that the latch fits together easily. Tighten
the screws when latch is properly located.
3. Connect the Power Cord.
4. Turn on power to the eWire.
Repairs/Adjustments

REP 9.5 Element Feeder Drawer Latch Replacement

PARTS LIST ON PL 5.27
Use this procedure to remove and install the Latch for the Element
Feeder Drawer. Note that the latch is in two parts, on the drawer and
frame.
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Turn off Power to the eWire.
2. Disconnect the Power Cord.
3. Locate the male half of the Latch on the back of the drawer. Remove
the Latch by removing the M4 Screws (2) and Washers.
01/26/2018
4-168
GBC eWire