1. Install the new Sensor by tightening the M3 Screw. Use tab for
alignment.
2. Connect the Sensor Cable.
3. Close the Lid
4. Connect the Power Cable
5. Turn power ON to the eWire.
Repairs/Adjustments
REP 8.6 Holder Position Stack Sensor S37
PARTS LIST ON PL 5.20
Use this procedure to remove and replace the Holder Position Stack
Sensor S37.
DO NOT REPLACE OR ADJUST THIS SENSOR UNLESS DIRECTION
TO VIA AN ESCALATION
Removal Procedure
WARNING
Do not perform repair activities with the power on or electrical power
supplied to the machine. Some machine components contain
dangerous electrical voltages that can result in electrical shock and
possible serious injury. See Section 0, page vi for other languages.
1. Turn off Power to the eWire.
2. Disconnect the Power Cord.
3. Raise the Lid and Lower Bypass.
4. Locate the Holder Position Stack Sensor. Refer to PL 5.20 and GP
6.4.3.
5. Disconnect the Sensor Cable.
6. Remove the Sensor by removing the M3 Screw. DO NOT REMOVE
THE SCREW MARKED WITH ORANGE PAINT
01/26/2018
4-148
GBC eWire