Front Brake Pad - Subaru Legacy 2004 Service Manual

BRAKE

2. Front Brake Pad

A: REMOVAL
1. 15-INCH TYPE
1) Lift-up the vehicle and remove the front wheels.
2) Remove the caliper bolt.
3) Raise the caliper body and support it.
NOTE:
Do not disconnect the brake hose from caliper
body.
4) Remove the pad.
NOTE:
If the brake pad is difficult to remove, proceed as
follows:
(1) Remove the caliper body from support.
(2) Remove the support.
(3) Place the support in a vise between wooden
blocks.
(1) Support
(2) Wooden block
Front Brake Pad
BR-00339
BR-00012
(1)
(2)
BR-00013
(4) Attach a rod of less than 12 mm (0.47 in) di-
ameter to the shaded area of the brake pad, and
strike the rod with a hammer to drive brake pad
out of place.
2. 16-INCH TYPE
Refer to 15-inch type. <Ref. to BR-16, 15-INCH
TYPE, REMOVAL, Front Brake Pad.>
3. 17-INCH TYPE
Refer to 15-inch type. <Ref. to BR-16, 15-INCH
TYPE, REMOVAL, Front Brake Pad.>
B: INSTALLATION
1. 15-INCH TYPE
1) Apply a thin coat of Molykote M7439 to the pad
clip.
2) Apply a thin coat of Molykote AS880N (Part No.
K0779YA010) to the frictional portion between pad
and pad inner shim.
BR-16
BR-00014
BR-00340
BR-00238