Excluded-Address - Dell S6100 Configuration Manual

Parameters
name
Defaults None
Command Modes DHCP <POOL>
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0

excluded-address

Prevent the server from leasing an address or range of addresses in the pool.
Syntax excluded-address [address | low-address high-address]
Parameters
address
low-address
high-address
Defaults None
Command Modes DHCP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
Give a name to the group of addresses in a pool.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Enter a single address to be excluded from the pool.
Enter the lowest address in a range of addresses to be excluded from the pool.
Enter the highest address in a range of addresses to be excluded from the pool.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Dynamic Host Configuration Protocol (DHCP) 547