Dcbx Version - Dell S6100 Configuration Manual

Defaults Manual
Command Modes INTERFACE PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX
configuration on a port, use the show interface dcbx detail command.

dcbx version

Configure the DCBX version used on the interface.
Syntax dcbx version {auto | cee | ieee-v2.5}
To remove the DCBX version, use the dcbx version {auto | cee | ieee-v2.5} command.
Parameters
auto | cee | ieee-
v2.5
Defaults Auto
Command Modes INTERFACE PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
• auto-downstream: configures the port to accept the internally propagated DCB
configuration from a configuration source.
• manual: configures the port to operate only on administer-configured DCB
parameters. The port does not accept a DCB configuration received form a peer or a
local configuration source.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S6000-ON and Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the DCBX version type used on the interface, where:
• auto: configures the port to operate using the DCBX version received from a peer.
• cee: configures the port to use CDD (Intel 1.01).
• ieee-v2: configures the port to use IEEE 802.1az (Draft 2.5).
Data Center Bridging (DCB) 491