Show Ip Dhcp Snooping - Dell S6100 Configuration Manual

Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
Usage Information
Use this command on the interfaces where the DHCP clients are connected to forward the packets from clients to
DHCP server and vice-versa.
Example
Dell(conf-if-te-1/1/1/1)# ipv6 helper-address
X:X:X:X::X
VRF
Global

show ip dhcp snooping

Display the contents of the DHCP binding table or display the interfaces configured with IP Source Guard.
Syntax show ip dhcp snooping [binding | source-address-validation [discard-counters
[interface interface]]]
Parameters
Parameters
binding
source-address-
validation
discard-counters
interface interface
574 Dynamic Host Configuration Protocol (DHCP)
Description
Introduced on the S6100.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S4810, S4820T, S6000, S6000–ON, Z9000, and Z9500.
IPv6 helper address
VRF name.
Global address space
Description
Display the binding table.
Display the interfaces configured with IP Source Guard.
(OPTIONAL) Display the number of dropped packets.
(OPTIONAL) Specifies an interface to show the discard counters.
Enter any of the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.