Dell S6100 Configuration Manual page 675

Version
9.10(0.0)
9.10(0.0)
9.8(2.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.4(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.1.1.0
7.6.1.0
7.5.1.0
6.4.1.0
Usage Information
You cannot delete a physical interface.
By default, physical interfaces are disabled (shutdown) and are not assigned to an IP address or switchport. To
place an interface in Layer 2 mode, ensure that the interface's configuration does not contain an IP address and
enter the switchport command.
You can create up to 64 tunnel interfaces. The tunnel is added as a logical interface with no default configuration.
To delete a tunnel interface, use the no interface tunnel tunnel-id command.
The tunnel interface operates as an ECMP (equal cost multi path) only when the next hop to the tunnel destination
is over a physical interface. If you select any other interface as the next hop to the tunnel destination, the tunnel
interface does not operate as an ECMP.
Example
Dell(conf)# int tengigabitethernet 1/1/2/1
Dell(conf-if-te-1/1/2/1)# exit
Dell(conf)#
Dell(conf)# int HundredGigE 1/10
Dell(conf-if-hu-1/10)# exit
Dell(conf)#
Dell(conf)# int FortyGigE 1/10/1
Dell(conf-if-hu-1/10/1)# exit
Dell(conf)#
Dell(conf)# int TwentyfiveGigE 1/1/1/2
Dell(conf-if-te-1/1/1/2)# exit
Dell(conf)#
Description
Introduced on the S3148.
Introduced on the S6100–ON.
Introduced on the S3100 series.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Added the support for interfaces.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on the E-Series.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced
Interfaces 675