Other–Config–Flag - Dell S6100 Configuration Manual

•
mtu
Enable the verification of the configured maximum transmission unit (MTU) value in the received RA packets.
Syntax mtu value
To reset the MTU value, use the no mtu value command.
Parameters
value
Defaults 0
Command Modes POLICY LIST CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.11(0.0)
9.10(0.0)
9.9(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.7(0.0)
Related Commands
•
•
other–config–flag
Enable the verification of the advertised other configuration parameter. If this command is not configured, the verification process is
bypassed.
Syntax other-config-flag {on | off}
To reset the other configuration parameter, use the no other-config-flag {on | off} command.
Parameters
on
off
ipv6 nd raguard policy policy-name
configuration mode.
Enter the maximum transmission unit value in bytes. The range is from 1,280 to 11,982
bytes.
Description
Introduced on the C9010.
Introduced on the S6100-ON.
Introduced on the Z9500.
Introduced on the Z9100-ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the S4810, S4820T, S5000, S6000, and Z9000 switches.
ipv6 nd ra-guard enable — configure the RA guard related commands.
ipv6 nd raguard policy policy-name
configuration mode.
Enter the keyword on to set the other-config-flag value as ON.
Enter the keyword off to set the other-config flag value as OFF.
— define the RA guard policy name and enter the RA guard policy
— define the RA guard policy name and enter the RA guard policy
Neighbor Discovery Protocol (NDP) 1037