Ipv6 Nd Disable-Reachable-Timer - Dell S6100 Configuration Manual

Version
9.8(1.0)
9.7(0.0)
9.5(0.1)
9.3(0.1)
Usage Information You can use this command to enable programming of /128 route prefixes in L3 host table or in LPM table. A
warning message is displayed when you enter this command stating that this setting takes effect for existing
routes only when IPv6 route prefixes are cleared from the routing table (RTM). To enable programming of /128
route prefixes in LPM table, use no ipv6 unicast-host-route command.
Example
Dell(conf)# ipv6 unicast-host-route
Warning: Command will take effect for existing routes only when IPv6
route prefixes are cleared from RTM
Dell(conf)#no ipv6 unicast-host-route
Warning: Command will take effect for existing routes only when IPv6
route prefixes are cleared from RTM
Dell(conf)#

ipv6 nd disable-reachable-timer

Keep the learnt neighbor discovery entries stateless so that the entries do not time out.
Syntax ipv6 nd disable-reachable-timer
To restore to default, use the no ipv6 nd disable-reachable-timer command.
Default Disabled
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.11.0.1
ipv6 nd dns-server
Configures Recursive DNS Server (RDNSS) addresses to be distributed via IPv6 router advertisements to an IPv6 device.
Syntax ipv6 nd dns-server {ipv6-RDNSS-address} {lifetime | infinite}
To remove the IPv6 RDSS configuration, use no ipv6 nd dns-server {ipv6-RDNSS-address}
{lifetime | infinite}
Parameters
ipv6-RDNSS-
address
Description
Introduced on the Z9100–ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Description
Introduced on the S3100 series, S3048–ON, S4048–ON, S4048T-ON, S4810, S4820,
S5000, S6000, S6010–ON, S6000–ON, S6100–ON, Z9100–ON, C9010, Z9500, MXL,
and FN IOM.
Enter the IPv6 Recursive DNS Server's (RDNSS) address. You can specify up to 4 IPv6
RDNSS server addresses.
IPv6 Basics 817