Dot1X Guest-Vlan - Dell S6100 Configuration Manual

Auth-Fail VLAN id:
Auth-Fail Max-Attempts:
Critical VLAN:
Critical VLAN id:
Mac-Auth-Bypass:
Mac-Auth-Bypass Only:
Tx Period:
Quiet Period:
ReAuth Max:
Supplicant Timeout:
Server Timeout:
Re-Auth Interval:
Max-EAP-Req:
Host Mode:
Auth PAE State:
Backend State:

dot1x guest-vlan

Configure a guest VLAN for limited access users or for devices that are not 802.1X capable.
Syntax dot1x guest-vlan vlan-id
To disable the guest VLAN, use the no dot1x guest-vlan vlan-id command.
Parameters
vlan-id
Defaults Not configured.
Command Modes CONFIGURATION (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
8.3.11.1
7.6.1.0
Usage Information
1X authentication is enabled when an interface is connected to the switch. If the host fails to respond within a
designated amount of time, the authenticator places the port in the guest VLAN.
400
3
Enable
400
Disable
Disable
30 seconds
60 seconds
2
30 seconds
30 seconds
60 seconds
2
SINGLE_HOST
Authenticated
Idle
Enter the VLAN Identifier. The range is from 1 to 4094.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the C-Series, E-Series, and S-Series.
802.1X 161