Show Ip Management-Route - Dell S6100 Configuration Manual

show ip management-route

View the IP addresses assigned to the Management interface.
Syntax show ip management-route [all | connected | summary | static]
Parameters
all
connected
summary
static
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.5.1.0
pre-6.1.1.0
Example
Dell# show ip management-route
Destination
-----------
10.1.2.0/24
798 IPv4 Routing
(OPTIONAL) Enter the keyword all to view all IP addresses assigned to all Management
interfaces on the switch.
(OPTIONAL) Enter the keyword connected to view only routes directly connected to
the Management interface.
(OPTIONAL) Enter the keyword summary to view a table listing the number of active
and non-active routes and their sources.
(OPTIONAL) Enter the keyword static to view non-active routes also.
EXEC
EXEC Privilege
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Gateway
-------
ManagementEthernet 1/1
State
-----
Connected