Dell S6100 Configuration Manual page 943

Defaults Not configured.
Command Modes INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.5.1.0
8.3.7.0
7.6.1.0
7.5.1.0
pre-6.2.1.1
Usage Information
When this command is configured, the VLAN is operationally UP if any of the interfaces specified in the track
ip command are operationally UP, and the VLAN is operationally DOWN if none of the tracking interfaces are
operationally UP.
If the track ip command is not configured, the VLAN's Layer 3 operational state depends on all the members of
the VLAN.
The Layer 2 state of the VLAN, and the Layer 2 traffic, is not affected by the track ip command configuration.
Related Commands
•
•
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Added support for 4-port 40G line cards on the E-Series.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
interface vlan — configure a VLAN.
tagged — specify which interfaces in a VLAN are tagged.
Layer 2 943