Debug Ip Igmp Snooping - Dell S6100 Configuration Manual

debug ip igmp snooping

Enable debugging of IGMP snooping packets on interfaces and groups.
Syntax debug ip igmp snooping [group address | interface]
•
•
Parameters
snooping
group-address
interface interface
Defaults Disabled.
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results. This command
displays packets for IGMP and IGMP snooping.
654 Internet Group Management Protocol (IGMP)
To disable debugging of IGMP snooping, use the no debug ip igmp snooping [group address |
interface] command.
To disable all debugging, use the undebug all command.
Enter the keyword snooping to enable debugging of IGMP snooping.
(OPTIONAL) Enter the IP multicast group address in dotted decimal format.
Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S4810, S4820T, S5000, S6000, S6000–ON, Z9000, and Z9500.