Lacp Port-Priority - Dell S6100 Configuration Manual

Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage Information This command applies to dynamic port-channel interfaces only. When applied on a static port-channel, this
command has no effect.
Related Commands
•

lacp port-priority

To influence which ports will be put in Standby mode when there is a hardware limitation that prevents all compatible ports from
aggregating, configure the port priority.
Syntax lacp port-priority priority-value
To return to the default setting, use the no lacp port-priority priority-value command.
Parameters
priority-value
Defaults 32768
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
914 Link Aggregation Control Protocol (LACP)
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
show lacp — display the LACP configuration.
Enter the port-priority value. The higher the value number, the lower the priority. The
range is from 1 to 65535. The default is 32768.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.