Excluded-Address - Dell S4810 Reference Manual

Defaults none
Command DHCP <POOL>
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
Version 8.2.1.0

excluded-address

Prevent the server from leasing an address or range of addresses in the pool.
S4810
Syntax
excluded-address [address | low-address high-address]
Parameters
address
low-address
high-address
Defaults none
Command DHCP
Modes
Command
This guide is platform-specific. For command information about other platforms,
History
refer to the relevant Dell Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version 9.0.2.0
Version
8.3.19.0
Version 8.3.11.1
Version 8.3.7.0
614
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series and S-Series.
Enter a single address to be excluded from the pool.
Enter the lowest address in a range of addresses to be
excluded from the pool.
Enter the highest address in a range of addresses to be
excluded from the pool.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Dynamic Host Configuration Protocol (DHCP)