Arp Inspection - Dell S6100 Configuration Manual

Commands to Configure Secure DHCP
DHCP, as defined by RFC 2131, provides no authentication or security mechanisms. Secure DHCP is a suite of features that protects
networks that use dynamic address allocation from spoofing and attacks.

arp inspection

Enable dynamic arp inspection (DAI) on a VLAN.
Syntax arp inspection
Defaults Disabled
Command Modes INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.2.1.0
Related Commands
•
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
arp inspection-trust — specify a port as trusted so that ARP frames are not validated against the binding table.
Dynamic Host Configuration Protocol (DHCP) 557