Description - Dell S6100 Configuration Manual

Usage Information
When you use this command to redistribute routes into a routing domain, the router becomes an autonomous
system (AS) boundary router. An AS boundary router does not always generate a default route into a routing
domain. The router still requires its own default route before it can generate one.
How a metric value assigned to a default route advertises depends on the metric-style command
configuration. If the metric-style command is set for Narrow mode and the metric value in the default-
information originate command is set to a number higher than 63, the metric value advertised in the LSPs
is 63. If the metric-style command is set for Wide mode, the metric value in the default-information
originate command is advertised.
Related Commands
•

description

Enter a description of the IS-IS routing protocol.
Syntax description {description}
To remove the description, use the no description {description} command.
Parameters
description
Defaults None
Command Modes ROUTER ISIS
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.11.1
pre-7.7.1.0
Related Commands
•
848 Intermediate System to Intermediate System (IS-IS)
redistribute — redistribute routes from one routing domain to another routing domain.
Enter a description to identify the IS-IS protocol (80 characters maximum).
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced.
router isis — enter ROUTER mode on the switch.