Ip Domain-Name - Dell S6100 Configuration Manual

Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.4.(0.0)
Usage Information
Use this command to associate the system with one or more DNS servers.
In a dual stack setup, the system sends both A (request for IPv4 — RFC 1035) and AAAA (request for IPv6 —
RFC 3596) record requests to a DNS server even if only the ip name-server command is configured.
Example
•
•
7.7.7.7

ip domain-name

Configures the default domain corresponding to a specific VRF. This domain is appended to the in complete DNS requests corresponding to
the specified VRF.
Syntax ip domain-name [vrf vrf-name] name
To undo the domain name configuration corresponding to a specific VRF, use the no ip domain-name [vrf
vrf-name] name command.
Parameters
vrf vrf-name
name
Defaults None
Command Modes EXEC
578 Dynamic Host Configuration Protocol (DHCP)
Description
Introduced on the S6100.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S-Series and Z-Series.
Dell(conf)#ip name-server vrf jay 2.2.2.2
Dell(conf)#ip name-server vrf jay 2.2.2.2 3.3.3.3 4.4.4.4 5.5.5.5 6.6.6.6
(Optional) Enter the key word vrf and then the name of the VRF to configure the
domain corresponding to that VRF.
Enter the name of the domain to be appended to the in complete DNS requests
corresponding to the specified VRF.