Show Isis Traffic - Dell S6100 Configuration Manual

Accept wide metrics:
Multi Topology Routing is enabled in transition mode.
Dell#

show isis traffic

This command allows you to display IS-IS traffic interface information.
Syntax show isis [vrf vrf-name] traffic [interface]
Parameters
vrf vrf-name
interface
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.2(0.2)
9.0.2.0
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to display IS-IS
traffic interface information corresponding to that VRF.
(OPTIONAL) Identifies the interface type and the interface following:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
EXEC
EXEC Privilege
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S6000.
none
Intermediate System to Intermediate System (IS-IS) 899