Ip Msdp Default-Peer - Dell S6100 Configuration Manual

ip msdp default-peer

Define a default peer from which to accept all source-active (SA) messages.
Syntax ip msdp default-peer peer address [list name]
To remove the default peer, use the no ip msdp default-peer {peer address} list name
command.
Parameters
peer address
list name
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.4.1.0
Usage Information If a list is not specified, all SA messages received from the default peer are accepted. You can enter multiple
default peer commands.
988 Multicast Source Discovery Protocol (MSDP)
Enter the peer address in a dotted decimal format (A.B.C.D.)
Enter the keywords list name and specify a standard access list that contains the RP
address that should be treated as the default peer. If no access list is specified, then all
SAs from the peer are accepted.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added the list option and removed the prefix-list option.
Introduced