Fefd-Global - Dell S6100 Configuration Manual

Parameters
seconds
Defaults 15 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
Legacy E-Series
command.
Related Commands
•
•

fefd-global

Enable FEFD globally on the system.
Syntax fefd-global [interval seconds][mode {normal | aggressive}]
To disable FEFD globally, use the no fefd-global [mode {normal | aggressive}] command.
Parameters
interval seconds
normal
aggressive
Enter a number as the time between FEFD control packets. The range is from 3 to 300
seconds. The default is 15 seconds.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
fefd — enable far-end failure detection.
fefd-global — enable FEFD globally on the system.
Enter the keyword interval followed by the number of seconds to wait between FEFD
control packets. Range is from 3 to 300 seconds. Default is 15 seconds.
(OPTIONAL) Enter the keywords mode normal to change the link state to "unknown"
when a far-end failure the software detects on that interface. When the interface is
placed in "unknown" state, the software brings down the line protocol. The default is
Normal mode.
(OPTIONAL) Enter the keywords mode aggressive to change the link state to "error-
disabled" when a far-end failure the software detects on that interface. When an interface
is placed in "error-disabled" state, t enter the fefd reset command to reset the
interface state.
Layer 2 951