Multicast - Dell S6100 Configuration Manual

The multicast commands are supported by Dell Networking OS on all platform.
IPv4 Multicast Commands
The following section contains the IPv4 multicast commands.
clear ip mroute
Clear learned multicast routes on the multicast forwarding table. To clear the protocol-independent multicast (PIM) tree information base,
use the clear ip pim tib command.
Syntax clear ip mroute [vrf vrf-name] {group-address [source-address] | * | snooping}
Parameters
vrf vrf-name
group-address
[source-address]
*
snooping
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
9.2.(0.0)
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to configure this
setting on that VRF.
NOTE: Applies to specific VRF if input is provided, else applies to Default
VRF.
Enter the multicast group address and source address (if desired), in dotted decimal
format, to clear information on a specific group.
Enter * to clear all multicast routes.
Enter the keyword snooping to delete multicast snooping route table entries.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Added support for keyword snooping on the Z9000, S4810, and S4820T.
33

Multicast

Multicast 1017