Neighbor Local-As - Dell S6100 Configuration Manual

neighbor local-as

To accept external routes from neighbors with a local AS number in the AS number path, configure Internal BGP (IBGP) routers.
Syntax neighbor {ip-address | peer-group-name} local-as as-number [no-prepend]
To return to the default value, use the no neighbor {ip-address | peer-group-name} local-as
command.
Parameters
ip-address
peer-group-name
as-number
no prepend
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information
If a local-as is configured, BGP does not allow for the configuration of BGP confederation. Similarly, if BGP
confederation is configured, then BGP does not allow the configuration of local-as.
This command automatically restarts the neighbor session for the configuration to take effect.
Enter the IP address of the neighbor in dotted decimal format.
Enter the name of the peer group to set the advertisement interval for all routers in the
peer group.
Enter the AS number to reset all neighbors belonging to that AS. The range is from 0 to
65535 (2 byte), from 1 to 4294967295 (4 byte) or from 0.1 to 65535.65535 (dotted
format).
Specifies that local AS values do not prepend to announcements from the neighbor.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Border Gateway Protocol 387