Track Interface Ip Routing - Dell S6100 Configuration Manual

Configure the UP and DOWN thresholds for each tracked route with the threshold metric command. The
default UP threshold is 254; the default DOWN threshold is 255. The notification of a change in the state of a
tracked object is sent when a metric value crosses a configured threshold.
The tracking process uses a protocol-specific resolution value to convert the actual metric in the routing table to a
scaled metric in the range 0 to 255. You can configure the resolution value used to scale route metrics for
supported protocols with the track resolution ip route and track resolution ipv6 route
commands.
Related Commands
•
•

track interface ip routing

Configure object tracking on the routing status of an IPv4 Layer 3 interface.
Syntax track object-id interface interface ip routing
To return to the default setting, use the no track object-id command.
Parameters
object-id
interface
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
track ip route metric threshold
track resolution ip route – configure the protocol-specific resolution value used to scale an IPv4 route metric.
Enter the ID number of the tracked object. The range is 1 to 500.
Enter one of the following values:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a tunnel interface, enter the keyword tunnel.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Description
Introduced on the S6100-ON.
Introduced on the Z9100-ON.
– configure object tracking on the threshold of an IPv4 route metric.
Object Tracking 1053