Cam-Acl - Dell S6100 Configuration Manual

Usage Information
For the new settings to take effect, save the new CAM settings to the startup-config (write-mem or copy run
start), then reload the system.
The total amount of space allowed is 4 FP Blocks.
Example
Dell# configure
Dell(conf)# cam-acl-egress ?
default
l2acl
Dell(conf)# cam-acl-egress l2acl ?
<1-4>
Dell(conf)# cam-acl-egress l2acl 1 ?
ipv4acl
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ?
ipv6acl
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl ?
<0-4>
Dell(conf)# cam-acl-egress l2acl 1 ipv4acl 1 ipv6acl 2
Dell(conf)#

cam-acl

Allocate space for IPv6 ACLs.
Syntax
cam-acl {default | l2acl 1-10 ipv4acl 1-10 ipv6acl 0-10 ipv4qos 1-10 l2qos
1-10}
Parameters
default
l2acl 1-10 ipv4acl
1-10 ipv6acl 0-10
ipv4qos 1-10 l2qos
1-10
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
832 IPv6 Access Control Lists (IPv6 ACLs)
Reset Egress CAM ACL entries to default setting
Set L2-ACL entries
Number of FP blocks for l2acl
Set IPV4-ACL entries
Set IPV6-ACL entries
Number of FP blocks for IPV6 (multiples of 2)
Use the default CAM profile settings, and set the CAM as follows:
• L3 ACL (ipv4acl): 2
• L2 ACL(l2acl): 2
• IPv6 L3 ACL (ipv6acl): 0
• L3 QoS (ipv4qos): 2
• L2 QoS (l2qos): 2
Allocate space to support IPv6 ACLs. Enter all of the profiles and a range. Enter the CAM
profile name then the amount to be allotted. The total space allocated must equal 9. The
ipv6acl range must be a factor of 3 (0,3,6,9).
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.