Bgp Dmzlink-Bw - Dell S6100 Configuration Manual

Usage Information
All routers apply the bgp default local-preference command setting within the AS. To set the local
preference for a specific route, use the set local-preference command in ROUTE-MAP mode.
Related Commands
•

bgp dmzlink-bw

Enables BGP Link Bandwidth.
Syntax bgp dmzlink-bw
To disable BGP Link Bandwidth, enter the no bgp dmzlink-bw command.
Parameters
dmzlink-bw
Defaults N/A
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
Usage Information
Configuring or un-configuring the command brings down and brings up the BGP Route Manager, this results in
tear down and re-establishment of all active sessions.
Link Bandwidth has to be configured on the router to tell it to associate Link Bandwidth with prefixes (paths)
and/or to use Link Bandwidth in BGP Multipath route selection.
This is done under BGP configuration and is supported per address family – for IPv4 and IPv6 address families.
The configuration for a particular address family applies across all VRFs configured.
This command must be performed on the router which is attaching link bandwidth to prefixes (typically a border
router) as well as the router which is expected to load share traffic proportional to the bandwidth of the external
links.
set local-preference — assign a local preference value for a specific route.
Enter the keyword dmzlink-bw to enable BGP Link Bandwidth in BGP multipath.
Description
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S-Series.
Introduced on the Z9500.
Border Gateway Protocol 353