Show Cam-Ipv6 Extended-Prefix - Dell S6100 Configuration Manual

show cam-ipv6 extended-prefix

Display the current settings and next-boot settings for cam-ipv6 extended-prefix configuration. Display the cam-ipv6 extended-prefix
configuration.
Syntax show cam-ipv6 extended-prefix
Defaults None
Command Modes
EXEC
EXEC Privilege
Command History
Version
9.10(0.0)
9.8(1.0)
9.7(0.0)
9.5(0.1)
9.3(0.1)
Usage Information You can use this command to view the number of supported extended prefix entries in LPM configured. The
output also displays the current applied value and the new value that is applicable after the reboot of the device.
Example
Dell# show cam-ipv6 extended-prefix
Cam-Ipv6-LPM Extended Prefix
--------------------------------
Current Settings
cam-ipv6-max-/65-to-/128-Prefix : 2048
Dell(conf)#
ipv6 unicast-host-route
Enable programming of IPv6 /128 route prefixes in L3 host table.
Syntax
[no] ipv6 unicast-host-route
Defaults Enabled by default. By default, all the IPv6/128 route prefixes are installed only in L3 host table.
Command Modes CONFIGURATION
Command History
Version
9.10(0.0)
816 IPv6 Basics
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Description
Introduced on the S6100–ON.