Mac Learning-Limit Learn-Limit-Violation - Dell S6100 Configuration Manual

When a channel member is added to a port-channel and there is not enough ACL CAM space, the MAC limit
functionality on that port-channel is undefined. When this occurs, un-configure the existing configuration first and
then reapply the limit with a lower value.
Related Commands
•
•

mac learning-limit learn-limit-violation

Configure an action for a MAC address learning-limit violation.
Syntax mac learning-limit learn-limit-violation {log | shutdown}
To return to the default, use the no mac learning-limit learn-limit-violation {log |
shutdown} command.
Parameters
log
shutdown
Defaults None
Command Modes INTERFACE (conf-if-interface-slot/port)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.2.1.0
NOTE: If you configure this command on an interface in a routed VLAN, and after the MAC addresses
learned reaches the limit set in the mac learning-limit command, IP protocols are affected. For
example, VRRP sets multiple VRRP Masters and OSPF may not come up.
mac learning-limit mac-address-sticky
show mac learning-limit — display MAC learning-limit configuration.
Enter the keyword log to generate a syslog message on a learning-limit violation.
Enter the keyword shutdown to shut down the port on a learning-limit violation.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
— replace deprecated no-station-move parameter.
Layer 2 925