Show System Stack-Unit Fanout Configured - Dell S6100 Configuration Manual

Version
9.10(0.0)
9.10(0.0)
9.9(0.0)
9.8(2.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
Usage Information
Example
Dell# show interfaces vlan 10
Vlan 10 is up, line protocol is down
Address is 90:b1:1c:f4:99:ce, Current address is 90:b1:1c:f4:99:ce
Interface index is 1107787786
Internet address is not set
Mode of IPv4 Address Assignment: NONE
DHCP Client-ID: 90b11cf499ce
MTU 1554 bytes, IP MTU 1500 bytes
LineSpeed auto
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 2d17h26m
Queueing strategy: fifo
Time since last interface status change: 2d17h26m
Input Statistics:
Output Statistics:

show system stack-unit fanout configured

Displays the details about the fanned-out ports.
Syntax show system stack-unit stack-unit-number fanout configured
Parameters
stack-unit stack-
unit-number
fanout configured
Defaults None.
Command Modes
•
•
712 Interfaces
Description
Introduced on the S3148.
Introduced on the S6100–ON.
Added support to display the interface configurations corresponding to a range of ports.
Introduced on the S3100 series.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S-Series and Z-Series.
NOTE: This command also enables you to view information corresponding to a range of ports.
• You can specify multiple ports as port-range. For example, if you want to display information
corresponding to all ports between 1 and 4, specify the port range as show interfaces
interface-type 1 - 4.
0 packets, 0 bytes
0 packets, 0 bytes, 0 underruns
The stack Unit ID of the device.
Enter the keywords fanout configured to display the details about the fanned-out
ports.
EXEC
EXEC Privilege