Permit Udp - Dell S6100 Configuration Manual

permit udp

To pass UDP packets meeting the filter criteria, configure a filter.
Syntax permit udp {source mask | any | host ip-address} [operator port [port]]
{destination mask | any | host ip-address} [dscp] [operator port [port]] [count
[byte] [order] [fragments] [monitor [session-ID]] [no-drop]
To remove this filter, you have two choices:
•
•
Parameters
source
mask
any
host ip-address
dscp
operator
port port
destination
count
byte
order
fragments
monitor
Use the no seq sequence-number command if you know the filter's sequence number.
Use the no permit udp {source mask | any | host ip-address} {destination mask |
any | host ip-address command.
Enter the IP address of the network or host from which the packets were sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject to the filter.
Enter the keyword host and then enter the IP address to specify a host IP address.
Enter the keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
(OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two ports for the port
parameter)
Enter the application layer port number. Enter two port numbers if you are using the
range logical operand. The range is 0 to 65535.
Enter the IP address of the network or host to which the packets are sent.
(OPTIONAL) Enter the keyword count to count packets processed by the filter.
(OPTIONAL) Enter the keyword byte to count bytes processed by the filter.
(OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry.
The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lower-
order numbers have a higher priority). If you do not use the keyword order, the ACLs
have the lowest order by default (255).
Enter the keyword fragments to use ACLs to control packet fragments.
(OPTIONAL) Enter the keyword monitor then the session–ID to describe the traffic
that you want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface. The session–ID range is from 0 to 65535. For more information, see
"Flow-based Monitoring" in the Port Monitoring section of the Dell Networking OS
Configuration Guide.
Access Control Lists (ACL) 217