Dell S6100 Configuration Manual page 648

Version
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command.
Usage Information This command displays the IGMP database, including configured entries for either all groups on all interfaces, all
groups on specific interfaces, or specific groups on specific interfaces.
The following describes the show ip igmp groups command shown in the following example.
Field
Group Address
Interface
Mode
Uptime
Expires
Last Reporter
Example
Dell# show ip igmp groups
Total Number of Groups: 5
IGMP Connected Group Membership
Group Address Interface Uptime
225.0.0.0
225.0.0.1
225.0.0.2
225.0.0.3
225.0.0.4
Example (VLT)
Dell# show ip igmp groups
Total Number of Groups: 5
IGMP Connected Group Membership
Group Address Interface Mode Uptime Expires Last Reporter
225.0.0.0
225.0.0.1
225.0.0.2
225.0.0.3
648 Internet Group Management Protocol (IGMP)
Description
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series and C-Series.
Expanded to support the detail option.
Description
Lists the multicast address for the IGMP group.
Lists the interface type, slot and port number.
Displays the IGMP version used.
Displays the amount of time the group has been operational.
Displays the amount of time until the entry expires.
Displays the IP address of the last host to be a member of the IGMP group.
Vlan 100
Vlan 100
Vlan 100
Vlan 100
Vlan 100
NOTE: The asterisk (*) after the port channel number (Po 2) highlighted in the following example
indicates the port channel is VLT, that the local VLT port channel is down and the remote VLT port is up.
Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Vlan 100 IGMPv2 00:00:05 00:02:04 3.0.0.51
Expires
00:00:05 00:02:04
00:00:05 00:02:04
00:00:05 00:02:04
00:00:05 00:02:04
00:00:05 00:02:04