Tagged - Dell S6100 Configuration Manual

Dell(conf-if-vl-222)#do show vlan name test
Codes: * - Default VLAN, G - GVRP VLANs
Q: U - Untagged, T - Tagged
Dell(conf-if-vl-222)#
Example (OpenFlow
instance) *
O
O
O
Related Commands
•
•

tagged

Add a Layer 2 interface to a VLAN as a tagged interface.
Syntax tagged interface
To remove a tagged interface from a VLAN, use the no tagged interface command.
Parameters
interface
Defaults All interfaces in Layer 2 mode are untagged.
Command Modes INTERFACE VLAN
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Description
222 Inactive
NUM Status Description
1 Inactive
3 Inactive
6 Inactive
8 Inactive
12 Inactive
vlan-stack compatible — enable the Stackable VLAN feature on the selected VLAN.
interface vlan — configure a VLAN.
Enter the following keywords and the interface information:
• For a port channel interface, enter the keywords port-channel then a number.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
Q Ports
U Te 1/1/2/1
Q Ports
O Te 1/1/1/1
Layer 2 941