Dell S6100 Configuration Manual page 650

Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
E-Series legacy
command.
Usage Information IGMP commands accept only non-VLAN interfaces — specifying VLAN does not yield results.
The show ip igmp interface command does not display information corresponding to the loop-back
interfaces.
Example
Dell# show ip igmp interface
TenGigabitEthernet 1/1/1/1 is down, line protocol is down
TenGigabitEthernet 1/1/1/1 is down, line protocol is down
TenGigabitEthernet 1/1/1/3 is down, line protocol is down
TenGigabitEthernet 1/1/1/4 is up, line protocol is down
Example (VRF)
Dell# show ip igmp vrf BLUE interface
TenGigabitEthernet 1/1/1/1
650 Internet Group Management Protocol (IGMP)
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Internet protocol processing disabled
Internet protocol processing disabled
Internet protocol processing disabled
Internet protocol processing disabled
Vlan 20
Inbound IGMP access group is not set
Internet address is 35.0.0.1/24
IGMP is enabled on interface
IGMP query interval is 60 seconds
IGMP querier timeout is 125 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP immediate-leave is enabled for all groups
IGMP activity: 0 joins
IGMP querying router is 35.0.0.1 (this system)
IGMP version is 2
Inbound IGMP access group is not set
Internet address is 50.10.4.1/24
IGMP is up on the interface
IGMP query interval is 60 seconds
IGMP querier timeout is 0 seconds
IGMP max query response time is 10 seconds
IGMP last member query response interval is 1000 ms
IGMP immediate-leave is disabled
IGMP activity: 0 joins