Version
9.10(0.0)
9.8(1.0)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information
DCBX requires that you enable LLDP to advertise DCBX TLVs to peers.
Configure DCBX operation at the INTERFACE level on a switch or globally on the switch. To verify the DCBX
configuration on a port, use the show interface dcbx detail command.
debug dcbx
Enable DCBX debugging.
Syntax
debug dcbx {all | auto-detect-timer | config-exchng | fail | mgmt | resource |
sem | tlv}
To disable DCBX debugging, use the no debug dcbx command.
Parameters
{all | auto-detect-
timer | config-
exchng | fail | mgmt
| resource | sem |
tlv}
Defaults
None
Command Modes
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.7(0.0)
492
Data Center Bridging (DCB)
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S6000-ON and Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the type of debugging, where:
•
all: enables all DCBX debugging operations.
•
auto-detect-timer: enables traces for DCBX auto-detect timers.
•
config-exchng: enables traces for DCBX configuration exchanges.
•
fail: enables traces for DCBX failures.
•
mgmt: enables traces for DCBX management frames.
•
resource: enables traces for DCBX system resource frames.
•
sem: enables traces for the DCBX state machine.
•
tlv: enables traces for DCBX TLVs.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S6000-ON and Z9500.